ME1404 COMPUTER AIDED SIMULATION AND ANALYSIS LABORATORY

ANNA UNIVERSITY CHENNAI:: CHENNAI 600 025
CURRICULUM 2004
B.E. MECHANICAL ENGINEERING
SEMESTER – VII
ME1404 COMPUTER AIDED SIMULATION AND ANALYSIS LABORATORY

LIST OF EXPERIMENTS
A. Simulation 15
Simulation of Air conditioning system with condenser temperature and evaporator temperatures as input to get COP using C /MAT Lab.
Simulation of Hydraulic / Pneumatic cylinder using C / MAT Lab.
Simulation of cam and follower mechanism using C / MAT Lab.

Analysis (Simple Treatment only) 30
Stress analysis of a plate with a circular hole.
Stress analysis of rectangular L bracket
Stress analysis of an axi-symmetric component
Stress analysis of beams (Cantilever, Simply supported, Fixed ends)
Mode frequency analysis of a 2 D component
Mode frequency analysis of beams (Cantilever, Simply supported, Fixed ends)
Harmonic analysis of a 2D component
Thermal stress analysis of a 2D component
Conductive heat transfer analysis of a 2D component
Convective heat transfer analysis of a 2D component
TOTAL : 45
LIST OF EQUIPMENTS
(for a batch of 30 students)

Computer System 30
17” VGA Color Monitor
Pentium IV Processor
40 GB HDD
256 MB RAM

Color Desk Jet Printer 01
Software
ANSYS Version 7 or latest 15 licenses
C / MATLAB 15 licenses

PR1353 MECHATRONICS LABORATORY 0 0 3 100
(Common to Mechanical and Production VI Semester)

LIST OF EXPERIMENTS

Design and testing of fluid power circuits to control
(i) velocity (ii) direction and (iii) force of single and double acting actuators
Design of circuits with logic sequence using Electro pneumatic trainer kits.
Simulation of basic Hydraulic, Pneumatic and Electric circuits using software.
Circuits with multiple cylinder sequences in Electro pneumatic using PLC.
Servo controller interfacing for open loop
Servo controller interfacing for closed loop
PID controller interfacing
Stepper motor interfacing with 8051 Micro controller
(i) full step resolution (ii) half step resolution
Modeling and analysis of basic electrical, hydraulic and pneumatic systems using LAB VIEW
Computerized data logging system with control for process variables like pressure flow and temperature.

TOTAL : 45

LIST OF EQUIPMENT
(for a batch of 30 students)
Basic Pneumatic Trainer Kit with manual and electrical controls - 1 each
Basic Pneumatic Trainer Kit with PLC control - 1 No.
HYDROSIM & PNEUMOSIM Software / Automation studio - 10 sets.
8051 - Microcontroller kit with stepper motor and drive circuit
LABVIEW software - 2 sets
LAB VIEW software with Sensors to measure Pressure,
Flow rate, direction, speed, velocity and force. - 2 sets